Ballast board removal & installation – Kino Flo DS1 Ballast Board User Manual
Page 2
Ballast Board Removal & Installation
1) Remove reflector and two (2) screws.
2) Remove three (3) ballast board screws.
3) Remove AC input/output connector and
remove old ballast board.
4) Install new ballast board.
(Note: Do not remove protective cardboard.)
5) Install AC input/output connector and
three (3) ballast screws.
6) Replace reflector and two (2) screws.
For latest Warranty information and Certifications,
see Kino Flo website at www.kinoflo.com.
Environmental: Disposal of Old Electrical & Electronic Equipment.
This symbol on the product or on its packaging indicates that this product
shall not be treated as household waste. This product is made of recyclable
materials and should be disposed of in accordance with governmental regulations.
Kino Flo, Inc. 2840 N. Hollywood Way, Burbank, CA 91505, USA
Tel: 818 767-6528 website: www.kinoflo.com