Kino Flo Foto-Flo 44 - Manual (Page 5)

Optional Lollipops
allow mounting to
grip heads or baby
stands.
To reorient the Lock Lever, pull
Lever away from mount. This
disengages the Lever from the screw
mechanism and allows it to be
reoriented.
Note: You can also use a screwdriver
to adjust the travel. Pull back on Lever
and adjust the screw in the center of
the Lever.
The Silver ring loops
provide attachment
points for a safety
chain.
WARNING!
1) ALWAYS TURN OFF THE FOTO-FLO 44 BEFORE connecting or
disconnecting Lamps.
2) Use only with Sine wave inverters. Do not operate on SCR dimmers.
3) If powering the Foto-Flo 44 through a Dimmer Pack set the Dimmer to
Non-Dim Mode.
The 120 VAC unit requires 110 to 130 Volts AC 50/60 Hertz on an earth
grounded circuit; the 230 VAC unit requires 220 to 240 Volts AC on an earth
grounded circuit. The electronic ballasts operate at a high frequency of 25KHz.
The ballasts are dead–quiet and instant–on.
After the lamps are properly installed the fixture can be turned on.
5