Kino Flo Flathead 80 DMX (415, 455) - Manual (Page 8)

8
Select 4Bank Control Panel
Select/DMX 4Bank Control Panel
A) Circular Output Connector: Provides electrical power to the lamp head
with the use of a 4Bank extension cable.
B) DMX-In & DMX-Out: DMX-In receives DMX signals from Dimmer Board.
DMX-Out relays DMX signals through other Fixtures or Instruments.
(
Note: Each 4Bank DMX ballast (BAL-455 Series) has an
“ AUTO TERMINATE” feature. The last ballast that does not have an XLR
cable attached to the “Out” port will automatically terminate.)
C) Fuse: Provides circuit protection. Note: If Fuse is “blown” or “open”,
replace with same type of fuse rating as marked.
D) DMX Address: Sets DMX Address of Fixture.
(Channels 1~4 = Lamps; Channel 5 = 4ft/2ft)
E) DMX Indicator: Lights if valid DMX signal is present.
F) Manual Switches: Turns lamps on and off manually.
G) Lamp Select Switch: Set to 4ft for 4ft lamps and 2ft for 2ft lamps.
1 2 3 4
A B C D E F G