Kino Flo Image 85/45 DMX Series - Manual (Page 12)

12
DMX Image 85 Switching
DMX Image 45 Switching
DMX Operation
DMX Addressing
Prior to hanging any instruments set the
DMX address of each Fixture.
Push the tabs above or below the number
window to set the address.
(Valid addresses range from 001 to 512.)
The yellow light above the address block
will illuminate if a DMX signal is present.
Note: Manual lamp switching, HO/STD as well as remote hand-held control
(DIM-5) is disabled as soon as DMX cables are applied. For Manual control
with DMX cables plugged in, set address to “000”. There is a 5 second delay
when switching between DMX and Manual control.