Т³гж 10, Heating, Cooling – Klimaire KSIM Series User Manual User Manual
Page 10
9
1 hour
1 hour
Set
Temperature
Cooling
O
2 F
O
2 F
Heating
SLEEP operation
OPERATING INSTRUCTIONS
How the air conditioner works
O
2 F
O
2 F
1 hour
1 hour
Set
Temperature
SLEEP operation
7 hours timer off
7 hours timer off
AUTO operation
When you set the air conditioner in AUTO mode, it will
automatically select cooling, heating(cooling/heating
models only), or fan only operation depending on what
temperature you have selected and the room temperature.
The air conditioner will control room temperature
automatically round the temperature point set by you.
If the AUTO mode is uncomfortable, you can select
desired conditions manually.
SLEEP operation
When you push SLEEP button on remote controller during
cooling, heating(cooling only type without), or AUTO
operation , the air conditioner will automatically increase
O
(cooling) or decrease (heating) 2 F per hour for the first
two hours, then hold steady for the next 5 hours, after that
the unit will stop operation. The fan speed will be auto-
matically controlled. This feature can maintain the most
comfortable temperature and save more energy for you.
DRYING operation
The fan speed will be automatically controlled under dry
operation.
During the dry operation, if the room temperature is lower
O
than 50 F, the compressor stops operation and restarts
O
until the room temperature is above 54 F.
To achieve optimal performance, please note the following:
Adjust the air flow direction correctly so that it is not directed
on people.
Adjust the temperature to achieve the highest comfort level.
Do not adjust the unit to excessive temperature levels.
Close doors and windows on COOL or HEAT modes, or
performance may be reduced.
Use TIMER ON button on the remote controller to select a
time you want to start your air conditioner.
Do not put any object near air inlet or air outlet, as the efficiency
of the air conditioner may be reduced and the air conditioner
may stop running.
Clean the air filter periodically, otherwise cooling or heating
performance may be reduced.
Do not operate unit with horizontal louvre in closed position.
Optimal operation