LaserLyte CK-SW Programmable - Low Rez Size - Manual (Page 2)

Side Mount Laser Fits: S&W® J-Frame Revolvers
Installation:
Attach danger label to slide of gun near laser with
arrow pointing toward front sight.
Open the cylinder on your revolver and unload the gun.
Keep your cylinder open during installation.
Remove your grip on the revolver.
Remove the two side plate screws and store.
Align the plate holes with the screw holes on the revolver.
CK-SN: Fits model 637 and other exposed hammer frames
CK-SH: Fits model 642 and other shrouded hammer frames
If needed remount the laser on the correct plate and
tighten screws.
Mount the plate to the side of the revolver using the provided
screws.
Tighten your screws down and replace grip.
1
2
3
4
5
6
7
8
CK-SW
CK-SH
CK-SN
3
4
5
6 7 8
CK-SH
CK-SN
Open the cylinder
and unload the gun.
1 Keep cylinder open
during installation.
2
CK-SN
1
1 3
2
2
3
Laser Sight In:
Use the provided .035 Allen wrench to adjust the sight.
Always end adjustments on a clockwise turn.
right
left
Windage
1
1 2
2
3
Activation:
Press once turns laser on: constant or pulse.
Press and hold for 5 seconds to change mode.
Second: press turns laser off.
3
Auto-Off feature:
• After 5 minutes in any mode, warning pulse will activate.
• After 1 minute in warning pulse mode, laser will turn off.
• Press the switch during warning pulse for laser reset.
5 min.
6 min.
off
5 min.
5 sec.
up
down
Elevation
Make final adjustments at shooting range.
Moving
Laser
Dot
or or