LaserLyte CK-AMFZK - Large Rez Size - Manual (Page 2)

2
1
3
5
Installation:
L ASER L YTE
UNLOAD FIREARM.
Place on a raised surface.
DO NOT REMOVE THIS PIN. (FIGURE A)
Using punch and small hammer remove Ruger ® Frame
Pin #1. Insert LaserLyte ® Frame Insert Pin.
Tap out Pin #2 and replace with LaserLyte ® Insert Pin.
Place laser on gun, align holes and insert screws.
(Kel-Tec
® use frame adapter, then mount.)
Use both .062 Allen wrenches to tighten screws until snug.
Do not over tighten! Tighten down the battery cover and
check periodically.
4
Kel-Tec ® / Ruger ® .380 ACP Side Mount Laser
Read instructions completely before installing your laser. Failure to do so may result in
damage to your laser or firearm.
Attach danger label to side of gun near laser with arrow
pointing toward front sight.
The two LaserLyte ® frame pin screws are pre-loaded with a self-locking nylon patch.
If you un-install the CK-AMFZK, re-apply a self-locking material such as Lock-tite ®
Threadlocker Blue 242 ® to the LaserLyte ® frame pin screws before re-installing the laser.
Unload firearm.
1 2
4 5
#1
#1
3
#2 #2
#2
A
Kel-Tec ® frame adapter
L ASER L YTE
Attach danger label to slide of gun near
laser with arrow pointing toward front sight.
5 sec.
1
1 2 3
2
3
Activation:
Press once turns laser on: constant or pulse.
Press and hold for 5 seconds to change mode.
Second press turns laser off.
1
1 3
2
2
3
Laser Sight In:
Use the provided .035 Allen wrench to adjust the sight.
Always end adjustments on a clockwise turn.
Make final adjustments at shooting range.
Moving
Laser
Dot
up
down
Elevation
L ASER L YTE
LASERLYTE LASERLYTE
right
left
Windage
or
ON/OFF
LASERLYTE
LASERLYTE
or
LASERLYTE
LASERLYTE
LASERLYTE
CK-AMFZK
CK_AMFZK.indd 2 5/31/12 6:09 AM