LaserLyte NAA-VM - Large Rez Size - Manual (Page 2)

1
2
3
4
NAA-VM
Installation:
•
UNLOAD FIREARM.
•
Attach danger label to side of gun near laser with arrow pointing
toward front sight.
•
DO NOT TOUCH THESE SCREWS (Figure A).
While pointing firearm in safe direction place cylinder back into
gun.
Turn laser block 90 degrees to cylinder pin and slide into cylinder
pin groove.
Once fully seated in cylinder pull down on laser body and turn
towards muzzle locking laser in place.
When properly installed laser should not turn to sides.
* Read instructions completely before installing your laser.
Failure to do so may result in damage to your laser or firearm.
1 2
3 4
•
UNLOAD FIREARM.
•
Attach danger label to side of gun near laser with arrow pointing
toward front sight.
•
DO NOT TOUCH THESE SCREWS.
(Figure A) (Figure B)
To fit the Mini Master, remove
this screw and triangle block
1
1
2
3
Activation: laser has ambidextrous activation.
Press once turns laser on: constant or pulse.
Auto-Off Feature:
• After 5 minutes in any mode, warning mode pulse will activate.
• After 1 minute in warning pulse mode, laser will turn off.
• Press the switch during warning pulse for laser reset.
Press and hold for 5 seconds to change mode.
Second press turns laser off.
ON/OFF ON/OFF
2
5 SECOND HOLD TO CHANGE MODE
3
5 min.
5 min.
6 min.
Off
Laser for North American Arms ® Black Widow & Mini Master