LaserLyte UTA-FR - Large Rez Size - Manual (Page 2)

SCCY Firearms Gen 2 Pistols CPX-1 & CPX-2
1
UTA-FR
RIGHT SIDE LEFT SIDE
Installation:
• UNLOAD FIREARM.
• Attach danger label to side of gun near laser with arrow pointing
toward front sight
Place small button provided into button hole in left-side of laser body.
Lower right side of laser and gun onto the left side of laser, rocking the
two sides into place.
ENSURE PROPER BUTTON PLACEMENT.
SQUEEZE BOTH SIDES TOGETHER. While squeezing together, from the left
(non battery cover) side insert one of the provided 1/2" hex head screws.
Tighten the 1st screw until it catches, then repeat with the other screw.
Alternate, tightening both screws down until the gap between both sides of
the laser is closed.
* Read instructions completely before installing your laser.
Failure to do so may result in damage to your laser or firearm.
2
3
4
5
J3 C1
J1
U1 S1
Place right-side of laser body on gun, ensuring proper placement.
1 2
3
4 5
Installation: •
UNLOAD FIREARM
J3 C1
J1
U1 S1
L ASER L YTE
LASERLYTE
L ASER L YTE
5 sec.
1
1 2 3
2
3
Activation: This laser has ambidextrous activation.
Press once turns laser on: constant or pulse
Press and hold for 5 seconds to change mode.
Second press turns laser off.
1
1 3
2
2
3
Laser Sight In:
Use the provided .035 hex key to adjust the sight.
Always end adjustments on a clockwise turn.
Make final adjustments at shooting range.
Moving
Laser
Dot
Windage
Windage
Screw
or
Elevation
down
up right
left
ON/OFF
LASERLYTE
ON/OFF
LASERLYTE
L ASER L YTE L ASER L YTE
or
ON/OFF
LASERLYTE
ON/OFF
LASERLYTE
ON/OFF
LASERLYTE