LaserLyte LT-PRO - Large Rez Size - Manual (Page 2)

Laser Trainer Pro
Installation:
• THE SOUND ACTIVATED SWITCH IS ALWAYS LISTENING
•
THE BATTERIES ARE ALREADY INSTALLED. YOU MUST REMOVE THE
PLASTIC INSULATOR BEFORE OPERATION. SEE BATTERIES SECTION
FOR INSTRUCTIONS.
UNLOAD YOUR FIREARM!
Insert screw through plug & adapter and thread into taper of trainer.
Tighten or loosen screw for caliber fit.
Gently press the trainer into the muzzle of the pistol.
Ready your pistol and pull trigger to fire red laser dot.
(LaserLyte recommends the use of snap caps.)
When removing from your pistol, pull straight out!
Do not twist! Ensure all parts are out of barrel.
1
2
3
4
6
5
LT-PRO
LT-PRO Adapter Plug Screw Hex Key
2 3
4
5
6 Correct removal
NO
NO
***With the LT-TTC, remove the "Plug" from the LT-PRO***
When not in use: Insert into LT-PRO as shown.
Batteries: (3) 377
Unscrew Battery cap Install new batteries.
Remove batteries. Tighten battery cap
1
2
3
4
+ + +
Remove & discard insulator before initial use.
7
7