Bowens Esprit Gemini Bwl-0353 - Manual (Page 3)

www.bowens.co.uk www.bowens.co.uk
Introduction
Safety Notes
3 10
DO NOT:
• Use in an environment where moisture or flammable vapor is likely to come in contact with the unit.
• Plug the Gemini Esprit into a mains supply and a battery at the same time.
• Restrict air vents while in use.
• Use a unit with damaged housing, moldings, flash tube or modelling lamp.
If the unit is dropped or damaged in any way, always have it checked out before using.
• Operate the unit without a safe grounded (earthed) AC supply.
DO:
• Switch power off and disconnect from the supply before changing modelling bulb or flash tube.
• Disconnect the supply before changing the fuse. Never replace with a fuse of a different rating. A
spare fuse is fitted in the fuse holder.
• Excercise care when handling equipment that has been in use. The reflector and front end of the
unit can become Very Hot.
• Avoid placing cables where they can be tripped over. Protect from heavy, sharp or hot objects,
which may cause damage and replace damaged cables immediately.
• Due to the high voltage / high energy used in Esprit Gemini Units, all servicing must be carried out
by an authorised Service Centre.
• Remove the power cord by gripping the plug. NEVER pull the cord.
• Ensure that any extension cord used has a suitable current rating to prevent overheating and
never use coiled extension cords.
• ALWAYS remove the flash head covers before using.
Dear Valued Customer,
Thank you for choosing the Bowens Esprit Gemini professional flash system.
Accurate, ergonomic, powerful and simple to use, the Esprit Gemini was designed by working
closely with photographers to develop a flash that meets the standards demanded in professional
studios today.
All ‘S-Type’ accessories from the Bowens range can be used with the Esprit Gemini. For details of
all related products, please contact your local distributor, a list of which can be found at
www.bowens.co.uk.
In order to obtain the full benefit from your purchase, please take a few moments to familiarise
yourself with this user manual.
Thank you.
Bowens International Ltd.
Unit
Stored Energy (max)
Sync Voltage
Flash Colour Temperature
Circuit Protection
Flash Power Control
Modelling Lamp
Ready Indication
User Replaceable Flash Tube
Photocell
Audio Ready Signal
Recommended Modelling
Lamps
Weight
Dimensions (l x w x h)
Supply Voltage Range 230V
(117V)
Voltage Stabilisation
Typical Recycle Time
Full Power, 230V, 50Hz (117V 60Hz)
Guide Number
(Full power, 50° Keylite, ISO 100)
Flash Duration (t=0.5)
(Full power)
Modelling Power Control