Pantum P2500W - Manual (Page 43)

5-8
5.1.2. Configuration with Wi-Fi Direct
When Wi-Fi Hotspot is active, terminal (Station) users can find and connect the printer's
Wi-Fi Hotspot by searching for it. The Wi-Fi Hotspot is enabled by default. It can be connected
without a password and coexist with Station or wired network.
Feature Description Comment
1 SSID
Pantum-AP-XXXXXX by default
XXXXXX should be replaced with
the last three digits of the mac
address
The XXXXXX section can be
modified in WebPage
2 Frequency band Auto by default Can be modified in WebPage
3 IP Address 192.168.223.1 by default Can be modified in WebPage
4 Subnet Mask 255.255.255.0 by default Can be modified in WebPage
5 DHCP Service Enabled by default
6 DHCP service starting
address
192.168.223.100 by default Can be modified in WebPage
7 DHCP service ending
address
192,168,223,200 by default Can be modified in WebPage
5.2. Turn off the Wireless Device
If you want to disconnect the printer with the wireless network, you can turn off the wireless
device within the printer.
1. You can disconnect the wireless network by pressing the Wi-Fi button on the printer's
control panel for over 2 seconds.
2. To verify whether the wireless device is turned off, press and hold the Cancel/Continue
button to print a copy of the configuration page. The wireless network is disconnected
successfully if the printer's IP address on the configuration page is 0.0.0.0.