RCBS Universal Hand Priming Tool - Manual (Page 5)

Photo #3 removing/installing safety gate Photo #4 proper orientation of primer feed
retaining screw
The next step is to install the primer tray. At some point, primers will need to be
loaded into the tray. This can be done before or after the tray is attached to the
priming tool. The following instructions are for loading the tray with primers
before the tray is attached to the tool.
Photo #5 install primer tray into tool
First, remove the clear plastic lid from the primer tray and scatter some primers
onto the grooved surface of the green tray. Gently shake the green tray from
side to side and the primers will “flip over” and be positioned anvil side up for
feeding into the Universal Hand Priming Tool. Replace the clear plastic lid.
You’ll notice there is a “notch” cut into the lid that fits over the portion of the
tray that funnels the primers into the primer feed. Install the primer tray into the
primer feed on the tool (Photo 5). The small green slide in the tray lid is the
primer shut off. By sliding the shut off right or left you can either start or stop
the flow of primers into the primer feed. Photo #6 shows the primer shut off
slide in a position to stop the flow of primers. Photo #7 shows the primer shut
off slide in an open position to allow primers into the primer feed.