Reloop BEATPAD - VirtualDJ 8 Operation Guide - Manual (Page 11)

VirtualDJ 8 – Reloop Beatpad 11
Sampler mode
Press the SAMPLER mode button to set the PADs to Sampler mode.
Each one of the pads triggers a sample from
the selected Sampler Bank of VirtualDJ. If a
bank has less than 5 samples, both sides of
the Beatpad will control the same samples. If a
bank has more than 4 samples, the left side of
the Beatpad will control samples 1 to 4 and
the right side samples 5 to 8.
The LEDs of the Pads will tend to get the
assigned color of each sample, however the
colors may not match perfectly due to the
limited offered colors of the Pads.
Press the pads to trigger a sample.
Depending on the selected trigger mode, use
SHIFT and the same pads to stop the
sample.
If the SAMPLER mode is selected, press and
hold down the same Mode button to receive
the Sampler parameters.
Use Pads 1 and 2 to select the previous and
next available Sampler Bank.
Use Pads 3 and 4 to select the next sampler
trigger mode (On/off, Hold, Stutter and
Unmute)
F. FRONT
32. MIC INPUT. Connect a 1/4" microphone to this input. This input's audio signal is
routed directly to the Program Mix and Cue Mix.
33. MIC LEVEL. Adjust the gain of the microphone input channel.
34. HEADPHONES SOCKET. Connect your 1/4" headphones to this output for cueing
and mix monitoring.