Power tool safety rules – Bosch 1677MD User Manual

Page 2

Advertising
background image

-2-

Read and understand all instructions. Failure to follow all instructions listed
below, may result in electric shock, fire and/or serious personal injury.

SAVE THESE INSTRUCTIONS

Work Area

Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.

Do not operate power tools in explosive

atmospheres, such as in the presence of

flammable liquids, gases, or dust. Power
tools create sparks which may ignite the
dust or fumes.

Keep by-standers, children, and visitors

away while operating a power tool.
Distractions can cause you to lose control.

Electrical Safety

Grounded tools must be plugged into an

outlet properly installed and grounded in

accordance with all codes and

ordinances. Never remove the grounding

prong or modify the plug in any way. Do

not use any adaptor plugs. Check with a

qualified electrician if you are in doubt as

to whether the outlet is properly

grounded. If the tools should electrically
malfunction or break down, grounding
provides a low resistance path to carry
electricity away from the user. Improper
grounding can shock, burn or electrocute.
Grounded tools are equipped with three
conductor cord and three prong type plugs.

Before plugging in the tool be certain the

outlet voltage supplied is within the voltage

marked on the nameplate. Do not use “AC

only” rated tools with a DC power supply.

Avoid body contact with grounded

surfaces such as pipes, radiators, ranges

and refrigerators. There is an increased
risk of electric shock if your body is
grounded. If operating the power tool in
damp locations is unavoidable, a Ground
Fault Circuit Interrupter must be used to
supply the power to your tool. Electrician’s
rubber gloves and footwear will further
enhance your personal safety.

Don't expose power tools to rain or wet

conditions. Water entering a power tool will
increase the risk of electric shock.

Do not abuse the cord. Never use the

cord to carry the tools or pull the plug

from an outlet. Keep cord away from

heat, oil, sharp edges or moving parts.

Replace damaged cords immediately.
Damaged cords increase the risk of electric
shock.
When operating a power tool outside, use

an outdoor extension cord marked "W-A"

or "W." These cords are rated for outdoor
use and reduce the risk of electric shock.
Refer to “Recommended sizes of Extension
Cords” in the Accessory section of this
manual.

Personal Safety

Stay alert, watch what you are doing and

use common sense when operating a

power tool. Do not use tool while tired or

under the influence of drugs, alcohol, or

medication. A moment of inattention while
operating power tools may result in serious
personal injury.
Dress properly. Do not wear loose

clothing or jewelry. Contain long hair.

Keep your hair, clothing, and gloves away

from moving parts. Loose clothes, jewelry,
or long hair can be caught in moving parts.
Keep handles dry, clean and free from oil
and grease.
Avoid accidental starting. Be sure switch

is “OFF” before plugging in. Carrying tools
with your finger on the switch or plugging in
tools that have the switch “ON” invites
accidents.
Remove adjusting keys or wrenches

before turning the tool “ON”. A wrench or
a key that is left attached to a rotating part of
the tool may result in personal injury.
Do not overreach. Keep proper footing

and balance at all times. Proper footing
and balance enables better control of the
tool in unexpected situations.
Use safety equipment. Always wear eye

protection. Dust mask, non-skid safety
shoes, hard hat, or hearing protection must
be used for appropriate conditions.

!

WARNING

Power Tool Safety Rules

BM 2610917132 10-03 10/28/03 11:07 AM Page 2

Advertising
This manual is related to the following products: