Reloop IQ.2+ USB - Manual (Page 29)

NOTE!
Via the separate TAP/BPM button -23- you can manually adjust the bars
when effects are active.
14. DSP effects [see designations; numbers 13, 14, 15, 16, 18, 19, 24 & 25]
Besides the effect send/return loop and the beatcounter, the DSP effect unit
features 8 different digital effects (see below for an exact description).
First of all choose the required effect via the effect selection knob -14- and
determine the channel to which the effect has to be assigned to via the
effect assignment knob -16-. The designated channel is shown on the upper
left side of the LCD info display -13, I-. By using the X parameter knob -25- you
can adjust the effect's value that will then be shown on the LCD info display
-13, III-.
By using the Y parameter effect fader -18- you can adjust the designated
effect's intensity. The effect's value percentage is shown on the lower right
side of the LCD info display -13, IV-.
If the Y parameter effect fader is in the “Dry” position the effect will have an
intensity of 0%; this means the effect is not audible. If the y parameter effect
fader -18- is in the “Wet” position the effect has an intensity of 100%.
The beat assignment buttons for the DSP effect unit -24- show which bar
length corresponds to the designated time parameter. If the time parameter
does not exactly correspond to the bar lengths the two bar buttons that are
between this value will be illuminated (except the Pitch Shifter effect: In this
case the time parameter does not correspond to the channel's bar length but
to the overall speed).
By pushing the FX button -19- you can activate the effect unit (button is
illuminated). By pushing the button again the DSP effects will be deactivated.
NOTE!
The DSP effect unit is only available for use if the crossfader effect unit is
turned off. To obtain this the fader effect switch -15- must be in the “OFF”
position.
29
ENGLISH
IM_IQ2.qxp 10.07.2008 14:28 Uhr Seite 29