Revel B12 - Manual (Page 19)

19
Two-Channel Applications Without
An External Crossover (continued)
To make connections to a receiver or
2-channel pre-amplifier with full-range
outputs for left and right channels:
1. Connect a pair of cables to the left and
right main outputs on your
receiver/pre-amplifier.
2. Connect the other end of the cables to
the B12 subwoofer’s right and left line-
level inputs as shown in Figure 15
(below).
Note
This configuration applies to receivers with
pre-amp outputs, or to pre-amp/power-
amplifier configurations in which there are
two sets of "Main" outputs on the
pre-amplifier. If the receiver has jumpers
from the "Pre-" or Main-out" to the "Amp
in" connectors or if the pre-amplifier has
only one set of "Main-out" connectors, a
Y-adapter should be used to send the same
signal to both the main power amplifier
and the subwoofer(s). The "Tape Out" or
"Record Out" connectors cannot be used.
REVEL Concerta B12
Owner’s Manual
Figure 16: Connecting Multiple B12s
MULTIPLE B12 CONNECTIONS
Connections are made between multiple
B12s and a receiver/processor with a sub-
woofer output as shown in Figure 16
(below).
To make connections between two B12s
and a receiver/processor with a sub-
woofer output:
1. Connect a single cable from the sub-
woofer output on your receiver/proces-
sor to the single input on the Y-adapter
as shown in Figure 16 (below).
2. Connect cables from the two outputs
on the Y-adapter to the B12 left inputs
as shown in Figure 16 (below).
3. Additional B12s may be connected by
using additional Y-adapters.
Figure 15: B12 Connecton to Main Outputs