Revel C32 - Manual (Page 7)

7
Note
While the loudspeaker is upside-down, it
is recommended to position the spike
footing as desired. Refer to the Adjustable
Spike Footing section that begins on
page 11 for instructions.
LOUDSPEAKER OVERVIEW
DRIVER COMPLEMENT
The numbers in Figure 3 (above) correspond
with the numbered items in this section.
1. Tweeter
• 1-inch (25mm) titanium dome
• Large co-polymer surround for
linear operation over a wide
dynamic range
1 3 3
2
Pedestal Stand
(Optional)
Cabinet
Figure 3: Front View
The numbers in Figure 3 (above) correspond with the
numbered items in the Driver Complement section
that begins below.
6. Grasping the sides of the cabinet, place
the C32 on its side. Then, place the C32
in the upright position without allowing
the protective bag to become “stuck”
under the bottom of the cabinet.
7. When the C32 is in the upright position,
remove the protective bag.
• Ferrofluid for high-power handling
with reduced compression
• Magnetic shielding to prevent video
monitor interference
2. Midrange
• 3.5-inch (89mm) cone constructed
with Organic Ceramic Composite
cone material
• Die-cast basket to eliminate
coloration from resonances
• True pistonic operation for
increased freedom from coloration
• Two high-grade Neodymium
magnets placed inside the voice
coils for optimal magnetic shielding
• Copper ring inside the motor’s gap
for modulation control and low
distortion
• 1.5-inch (38mm) voice coil wound
on a fiberglass bobbin for high-
power handling and low distortion
• Optimized and shielded magnetic
circuits to minimize harmonic
distortion and prevent video monitor
interference
(continued on next page)