Revel M22 - Manual (Page 7)

7
LOUDSPEAKER OVERVIEW
DRIVER COMPLEMENT
The numbers in Figure 3 (left) correspond with the
numbered items in this section.
1. Tweeter
• 1-inch (25mm) titanium dome
• Under-hung with copper-clad aluminum
wire for low distortion
• Ferrofluid for high-power handling with
reduced compression
• Magnetic shielding to prevent video monitor
interference
2. Woofer
• One 6.5-inch (165mm) cone constructed
with Organic Ceramic Composite cone
material for low distortion
• True pistonic operation for increased freedom
from coloration
• A high-grade Neodymium magnet is
located inside the voice coil for optimal
magnetic shielding
• Copper ring inside the motor’s gap for
modulation control and low distortion
• Aluminum flux-stabilization ring for
modulation control and reduced distortion
• Butyl rubber surround for large, linear
excursion capabilities
• Carbon composite aluminum flat-wire
voice coil wound on a 2-inch (50mm) fiber-
glass bobbin for low mass and higher
power handling
• Vented center pole for improved heat
dissipation and low compression
Figure 3: Front View
The numbers in Figure 3 (above) correspond with the
numbered items in the Driver Complement section
that begins in the next column.