Richter KAP-N Series Bottom Drain Ball Valves - Manual (Page 11)

Installation and Operating Manual
Series KA-N, KAP-N, ball and stem
9520-067-en Revision 00
TM 6404 MPE/Wm Page 11 Edition 02/2006
9.2.2 KA-N with lever
Mount lever stop 577, spring gland follower 502
and packing gland follower 503. Tighten packing
gland follower until there is no gap between it and
the spring gland follower. See Sections 1.2 and
10.4.
Seal any tapped bores still open with plugs.
Attach lever 203.
9.2.3 KAP-N with actuator
Mount spring gland follower 502 and packing
gland follower 503. Tighten packing gland follower
until there is no gap between it and the spring
gland follower. See Sections 1.2 and 10.5.
Mount bracket 510 with the opening at right
angles to the direction of flow.
Mount coupling 804 and actuator 850. Observe
the actuator position in accordance with the
actuator operating manual.
9.3 Conversion from lever to
actuator
Select the actuator in accordance with the actuator
manufacturer's manual.
Remove lever 203.
Remove lever stop 577 and plug.
Check the fits of the coupling 804, bracket 510 and
actuator 850.
Mount bracket 510 with the opening at right angles
to the direction of flow.
Mount coupling 804 and actuator 850. Observe the
actuator position in accordance with the actuator
operating manual.
10 Drawings
10.1 Legend
101 main body
102 body end piece
200 ball
202 stem
203 lever
401
seat ring
403 packing bellows
405/1 thrust ring
502 spring gland follower
503 packing gland follower
526 retaining washer
554/1 washer
557 grounding spring washer
577 lever stop
804 coupling
includes:
500 ring
952 pressure spring
980/1 round head grooved pin
850 actuator
901/x hex.
screw
902/1 stud screw
904/1 set screw
914/2 hex. Socket screw (only F07)
920/x hex. nut
936/x toothed lock washer