Clarion BLT370 - Manual (Page 17)

17
BLT370
Basic Operations
•
Turning on the power
The unit turns on immediately when power is supplied. It can only be turned
off if car engine is off.
• Resetting the Transceiver unit
This function is used to restore to factory default setting and clear all the
pairing information.
1. Press the [RESET] button once to perform reset function.
Notes:
• Transceiver will remain as power on state.
• The previously-connected device(s) may still hold the Transceiver information. Thus
if the device initiate a Bluetooth ® connection when the Transceiver is in pairing
mode, the connection may be successful.
• Activating Bluetooth ® Transceiver pairing mode
1. Turn on the Transceiver by powering up the car audio system, note that
the Red LED blinks once every 5 seconds to confirm that the power is on.
2. Press and hold the [ ] and [ ] buttons simultaneously for 2 seconds
or longer to activate Bluetooth ® pairing mode.
Note:
• If no device is paired to the Transceiver after 3 minutes, pairing mode will be
cancelled.
For more information on Bluetooth ® pairing, please see chapter “Pairing
Sequence” on page 11.
5. OPERATIONS FOR BLUETOOTH
® AUDIO/MOBILE-
PHONE TRANSCEIVER UNIT
1EN_OM_Receiver BLT370.indd 17 8/15/07 3:10:40 PM