Sindoh A610dn - Manual (Page 63)

Using the Printer
3-
19
② In the window above, change the figure with the 【◀】 or 【▶】 button.
③ Press the 【OK】 button to show the current values and move to the next step.
Enter IP Address
010. . .
④ Repeat ② and ③ to enter the 12-digit IP address.
⑤ If you want to use the default value, ‘0’, press the 【OK】 button.
⑥ Enter the last digit of the IP address, and then press the 【OK】 button to save the IP address and
go to the upper menu.
⑦ To correct the number, press the 【 】 button. You will move back through the numbers one by one.
⑧ To cancel all, press the 【 】 button. You will go to the upper menu.
⑨ Enter 12-digit address using th e same method for Netmask, Gateway, etc.
⑩ To maintain the current setting of the IP Address/Netmask/Gateway, press the 【 】 button.
The current setting is maintained and the dialog changes to the next entry input.
Using Network Setting Software:
1 Connect the USB cable, and then turn on the device. At this point, the printer must not be connected to
the device via the USB cable.
2 Run the network setting utility software “SINDOH PRINTER Network Configuration.”
3 In the left window, go to [TCP/IP -> Wired].
4 For IPv4, select TCP/ IPv4; for IPv6, select TCP/IPv6.
5 ① IP Automatic Setting(DHCP): Select [Use Static IP] and then press the 【OK】 button.
② IP Manual Setting: Select [Use DHCP IP] to enter network setting, and then press the 【OK】 button.