Sky-Watcher EQ8 - Manual (Page 4)

4
5. Assemble the 3 adjustable spider trusses as shown in Fig 1.1d and Fig 1.1e . Do not tighten
the thumb screws at this moment.
6. Slide the central post up/down in the clamp (Fig. 1.1c) to the proper height and then tighten
the 3 thumb screws on the spider trusses to prevent the central post from falling.
7. Tighten both hex nuts on the clamp to secure the central post in the clamp. The two nuts
MUST be tightened in an alternate manner to avoid damage to the clamp. Do not over
tighten the two nuts.
8. The tripod can be placed directly on a level ground, or it can be placed on the 3 adjustable
stands as shown in Fig 1.1f.
• Put the tips of the tripod on the three adjustable stands.
• Turn the leveling screw to raise/lower a leg.
• Tighten the locking ring when the tripod top is leveled.
(Fig. 1.1d).
• The small holes at the side of the leveling screw and the locking ring can accept a metal
bar for turning the screw and the ring.
Fig. 1.1d Fig. 1.1e
PART I: SETTING UP THE EQ8 MOUNT
Thumb Screw
Spider Truss
See Fig. 1.4
Leveling Screw
Locking Ring
Adjustable Stands
Fig. 1.1f