SONIQ ANB300 - Manual (Page 5)

4
Basic Operation
Listening to Aux-in
1.Connect the mains adaptor to the DC power socket on the rear of the unit, and
then plug the adaptor into the wall outlet, then the LED indicator will light up.
2.Press and hold Standby button to enter standby mode.
1.Insert the plug of a 3.5mm audio cable into the headphone jack on your audio
device (mobile phone ,computer,MP3 player etc),and then insert the other of the
cable into AUX IN jack , blue indicator will keep lighting.
2.When the player connect the AUX input terminal, the player will disconnect the
bluetooth connection automatically.
3.When the player disconnect the AUX input terminal, the player will return to the
previous bluetooth connection.
4.When the player connect the AUX input terminal , Previous/Next are only control
by the extra devices.
5.Press VOL- and VOL+ buttons on the unit to adjust volume level.
Pairing bluetooth devices
1.Turn on the unit , press and hold button for 2 seconds to search new
bluetooth device , then blue and red keep flashing , your speaker starts to search
for bluetooth device. The unit will search existed bluetooth device automatically
when it switch on.
2.Operate your bluetooth device to pair with the speaker. After successful pairing,
your speaker will sound a prompt tone and power LED and the model of player
will show”ANB300” on mobile phone.
3.Press button to play next music and press button to play previous music.
4.Press VOL- and VOL+ buttons on the unit to adjust volume level.
NOTE: Searching takes about 60 seconds ,even if no bluetooth devices are found.
Installing the adaptor