SONIQ I400 - Manual (Page 10)

LISTENING TO AN iPod
Connecting an iPo o the i400
1. Remove the plastic cover from the dock.
2. Insert the iPod / iPhone as shown . This unit is designed to make use
the adaptor supplied with yo Pod. Should you not have access to
this adaptor, there are a set of adaptors supplied with this unit. For
more details, see page 19.
3. Switch to iPod mode. Press the iPod button on the remote or press
the FUNCTION button repeatedly until you reach iPod.
Playback Controls
Below is a list of functions .
PLAY/ PAUSE: Press once to begin playback, press again to pause.
STOP: Stops playback.
ENTER: This button works as the select button on an iPod.
:Skips to previous or next track.
REPEAT: As same as described in the CD section Page 15.
MENU: For some iPods, press this button to activate the iPod menu .
/ NAVIGATION BUTTONS: Pressing these will scroll up or down
through the iPod menu.
NOTE: When activating the iPod mode, if the iPod power is very low,
the unit may not authenticate the accessory “Authenticated Is Fail!
Try Again!” will appear on the display. Leave the iPod docked for a few
minutes to charge, then remove and dock again.
It i vailable to connect an external audio source like an MP3 player
using a 3.5mm audio cable (not supplied).
CONNECTING EXTERNAL AUDIO SOURCES
External audio sources such as non iPod MP3 players can be
connected using a 3.5mm to RCA audio (not supplied).
1. Connect one end of the cable to the MP3 players headphone/ line
output and the other end to the AUX IN input on the back of the unit.
2. Press the FUNCTION button repeatedly until you reach the AUX-IN
option or press the AUX-IN button on the remote control.
3. Adjust the volume.
NOTE: The volume output is effected by the volume level on the
source when using a headphone output ie: MP3 player. So make
sure the volume is set to about 70-80
to avoid distortion).
ADVANCED OPERATION
Factory Reset
There may be times when you need to reset the i400 back to its original
factory setting.
1. Press the MENU button, then use the </> buttons to cycle the options
until you reach <System>. Press the ENTER button.
2. When you see <Factory Reset>, press the ENTER button.
3. Select <Yes> using the </> buttons, then press ENTER to start the
reset process.
NOTE: Once the reset has taken place, you will lose all your stored
DA B a nd FM, and the internal DA egistry.
17 18
/
Listening to an iPod Connecting External Audio Sources
+ + B r
^
^
ur i
d t
s a
% (