SONIQ IM311B - Manual (Page 6)

- 9 - - 10 -
This system supports a variety of equalizers and sound effects.
During playback, press the
PRESET EQ button to select a desired music mode. Each time the PRESET EQ button is pressed,
the music mode will be changed to the next one as follows:
-> (ROCK) -> -> (CLASSIC)
PreSet eQ
CD Mode
1. During playback, press the DISPLAY button repeatedly to shuffle between the CD playback mode and the current time.
2. When stopped, press the DISPLAY button to shuffle between the total number of CD tracks and the current time.
Radio Mode
• Press the DISPLAY button to shuffle between the current radio station and the current time.
iPod/AUX IN Mode
• Press the
DISPLAY button to shuffle the “iPod” or “AU” icon between the current time.
DiSPlay function
timer Setting
The timer function will turn the unit on at a preset time.
To Set Timer
1. In standby mode, press and hold the TIMER button on the remote control until the TIMER indicator blinks.
2. Press and hold the PROG/MEM/ button until the hour digits blink.
3. Press the or button to adjust the desired hours then press the PROG/MEM/ button once to confirm. The minute
digits blink.
4. Press the or button to adjust the desired minutes then press the PROG/MEM/ button once to confirm.The TIMER
indicator will stop blinking and remain on.
5. The unit will wake up to “RADIO”, “ iPod” ,“CD” or “AUX IN” when the timer reaches the preset time.
• For RADIO timer, first tune in to a desired station.
Press the STANDBY/ON button to enter standby mode, then set the timer following the above steps.
• For CD timer, first press the FUNCTION button to CD mode and insert one CD into the unit.
Press the STANDBY/ON button to enter standby mode, then set the timer.
• For AUX IN timer, first connect the plug to the AUX IN jack in back panel. Press the STANDBY/ON button to enter
standby mode, then set the timer.
• For iPod timer, first insert your iPod into the connector, press the FUNCTION button to iPod mode. Press the STANDBY/
ON button to enter standby mode, then set the timer.
Note: Before setting timer, you can adjust the volume levels in RADIO/ CD/iPod/AUX IN mode for the timer.
To Cancel Timer
• Press and hold the TIMER button on the remote control until the TIMER indicator goes out.
Note: No Alarm (Buzzer Timer) feature is provided in this unit.
The sleep timer automatically turns the unit off after a certain time.
1. While the unit is on, press the
SLEEP button and “ ” appears on the display.
2. Press the SLEEP button repeatedly to select the desired sleep time as below:
3. The unit will automatically turn off once it counts down the sleep time.
• To clear the preset sleep time press the
SLEEP button until “ ” appears.
SleeP timer Setting
aux in connection
Connecting to AUX IN for Other Sound Sources
You can connect audio devices such as your iPod or CD players to the unit through the AUX IN jack. Use the Line-in cable
(not supplied), connect the AUX IN jack on the back panel to the Line Out or Earphone jack of the other audio devices.
Listening to the Connected Device
1. Press the
FUNCTION button to AUX IN mode and “AU” is shown on the display.
2. Turn on the audio device you’ve attached to the AUX IN jack.
maintenance
Cleaning the Unit
Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft cloth.
Cleaning the CD
If the CD skips or will not play, the disc may need to be cleaned.
Before playing, wipe the disc from the center outwards with a cleaning cloth. After playing, store the disc in its case.
Handling the Disc
Only touch the CD on the edge to avoid fingerprints on its surface.
Do not stick paper or tape nor write anything on the surface.