CompuSTAR 2WSHR LED - Manual (Page 5)

8
Trunk Release
Press the button for 2 seconds in order to unlock and release your trunk
door. Note that the trunk release function will not only release the trunk but will
unlock all the doors as well.
Query Function allows you to visually monitor the status of your car by looking
at the remote-pager LED icons. Press buttons
+ for a 2 second
to activate the Query Function.
Press the button for 2 seconds to enter Panic Mode. In this mode, the car
will arm if not armed already and the siren will activate and the parking lights will
flash. In order to disengage Panic Mode, press the
button for a 1/2 second.
Then, press the button for a 1/2 second to lock/arm your vehicle.
If Anti-Jacking option has been programmed (ask your dealer if you
like to have this option) and the Ignition-Kill has is been installed , the
Panic Mode works as Anti-Jacking if the key is in the ignition. If Anti-
Jacking mode is activated while key is in the ignition ;
a)Siren will go off for 1.5 minutes, and b) Ignition-Kill will be activated
after the first 30 seconds. That is to give warning to the hijacker for the
first 30 seconds and then to disconnect the ignition to stop the vehicle.
Query Function
Panic Mode
Dual Stage Shock Sensor
7
Press buttons + for 2 seconds to activate or deactivate the dual stage
shock sensor. The dual stage shock sensor will activate 30 seconds after the
Compustar alarm is armed. When the dual shock sensor is engaged, the
remote-pager security alerts will be triggered by the following:
Light impact to your vehicle will activate the first stage shock sensor and
the car siren will chirp 4 times in addition to the parking lights flashing 4 times.
The remote pager unit will beep and the icon flashes rapidly.
Heavy impact to your vehicle will activate the second stage shock
sensor and the car siren will sound for 30 to 60 seconds and the parking lights
will flash for 30 to 60 seconds. The remote-pager will beep Both sound &
Icon rapidly.
Press the button for a 1/2 second to turn off the second stage shock sensor
sirens and flashing lights.
Note : If you lose your remote after you have armed the vehicle, use your
key to open the vehicle. The siren will go off. Turn on and off ignition 5
times with your key to shut off the siren and turn the system into valet
mode. Cancel the valet mode with remote later. See Valet mode.
Note : (Siren duration is 30 to 60 sec depending on the options set at the
time of initial installation.)