SONIQ MB415 - Manual (Page 5)

1. Press and hold the PAIRING/PLAY/PAUSE button to re-link the audio source device.
The Bluetooth indicator will blink.
2. Select MB415 on the audio source device for connecting. Bluetooth indicator will turn to
solid blue if the MB415 and the device have been re-connected successfully.
1. Power on the unit, switch to the radio mode by pressing the SOURCE button repeatedly
until the LED display shows the radio frequency.
2. Extend the FM TELESCOPIC ANTENNA on the left side of the unit fully for best
reception.
3. Press the SKIP UP/TUN+ or SKIP DN/TUN- button to fine tune radio station. Press and
hold the SKIP UP/TUN+ or SKIP DN/TUN- button to auto search radio station forward
or backward from the current frequency respectively (When an available station will be
found, the unit will broadcast it immediately and the searching will be stopped).
1. During playback, press and hold the PAIRING/PLAY/PAUSE button for storing the
current station until memory cell number flashes on the LED display.
2. Use the SKIP UP/TUN+ or SKIP DN/TUN- button to select the corresponding memory
cell for storing the station.
3. Confirm your selection by pressing the PAIRING/PLAY/PAUSE button again.
1. Press the PAIRING/PLAY/PAUSE button until memory cell number flashes on the LED
display.
2. Press the SKIP UP/TUN+ or SKIP DN/TUN- button repeatedly until the memory cell
number of the desired station flashes on the LED display.
3. Release the SKIP UP/TUN+ or SKIP DN/TUN- button, the unit will broadcast the station.
Press the VOL+/- button to adjust the volume output level.
1. Power on the unit, insert an USB into the unit.
2. Press the SOURCE button repeatedly to switch to USB mode until the wording of USB
shows on the LED display, the playback will start automatically.
3. Press the SKIP UP/TUN+ button or the SKIP DN/TUN- button to skip to the next track
or the previous track.
4. Press the PAIRING/PLAY/PAUSE button to pause the playback; press the button again
to resume normal playback.
The USB port is intended only for data transfer only, other devices cannot be
used with this USB connection. The use of USB extension cords is not recommended.
1. Connect the LINE IN jack on the left side of the unit to an audio source, for example,
MP3 player with an audio cable.
2. Press the STANDBY/ON button to turn the unit on.
3. Press the SOURCE button repeatedly to switch to LINE IN mode until the wording of
LINE shows on the LED display.
4. Use the native controls on the connected audio device to begin playing music through
the connected the unit.
FM RADIO
VOLUME LEVEL ADJUSTMENT
USB PLAYBACK
LINE IN
TUNING THE FM RADIO
STORING YOUR FAVORITE RADIO STATION
RECALL THE PRESET STATIONS
Important:
FM radio