SONIQ QFM32A - Manual (Page 2)

3.Attach the monitor bracket to the television:
3a.Select the television mounting hardware:
Always make sure the television is unplugged before threading any bolt into the back panel,
WARNING : Threaded bolts carefully into your television by hard before tightening, If feel resistance, remove the bolt immediately!
Locate the threaded inserts on the back of your flat panel television. Determine which of the
provided bolts is the correct diameter, Two
lengths in each of the following diameter are provided: M4,M5,M6,and M8. The shorter bolts are to be used if the back your television is flat. The
longer blots are designed to be used with either the M4/M5 Spacer (o) or the M6/M8 Spacer (n) on televisions with curved or recessed backs. The
long bolts are only to be used without a spacer in rare cases when the threaded in serts are deeply recessed inside the frame of the television.
3b.
WARNING: DO NOT LAY THE TELEVISION FACE DOWN ON THE GLASS, lean it up against a wall or other solid surface. Lying the
television down on the glass may cause permanent damage.
Diagram 4 shows the orientation of the monitor brackets on the back of the television. Each Monitor Bracket (c) must be held in place by 2 bolts.
Make sure both monitor brackets are level with each other by selecting the same hole in the bottom half of each bracket and adjust the arm
assembly in the center of the TV. If you determined that your television requires either the M4(k) or M5(j) diameter look at the diagrams 5 through 7
and select the one that best represents the shape of the back of your television and the arm assembly in the center of the back of TV. If
youdetermined that your television requires either the M6(l) or M8(h) diameter bolts, look at diagrams 8 through 10 and select the one that best
represents the shape of the back of your television.
Diagram 5-Flat Back TV with M4/
M5 Machine Screws
m
c
j,k
Diagram 6-Curved Back TV with
M4/M5 Machine Screws
c
j,k
Diagram 7-Recessed Back TV with
M4/M5 Machine Screws
c
j,k
Diagram 8-Flat Back TV with M6/
M8 Machine Screws
c
h,i
Diagram 9-Curved Back TV with
M6/M8 Machine Screws
C
l
Diagram 10-Recessed Back TV with
M6/M8 Machine Screws
q
c
m
o
m
o
l
h,i
n
n
l
h,i
Diagram4
Diagram3-A Diagram3-B Diagram3-C
r
p
M6 safety Bolt
r
p r
p
M6 safety Bolt
Diagram 1-A Diagram 1-B
2.Assembly the monitor bracket: As shown in diagram 2, put two 1” diameter Tube through
Arm Assembly (b) and monitor bracket (c) in turn, pay attention to getting the section of TV Rail
with round hole upward and the one with slot downward .Then according to Diagram 3-A,
place Vise Assembly (small) Monitor Bracker
TV Rail (c), put Axle pin (short) through the
round hole on monitor brackets and fit the arc face tightly against iameter tube, then as
shown in Diagram 3-B, put M6 Safety Bolt through Axle pin and screw in Visa Assembly. The
effect at the end of installation is shown in Diagram (3-C).Attention:do not tighten the screw at
this time so as to let monitor brackets smoothly slide on
Diameter Tube.
The tubes must extend beyond the outside edges of both monitor brackets and the Allen bolt in
all 6 vise assemblies must be tightened for the installation to be safe!
(c)
1” d
1”
Diagram2