SONIQ QPB302B - Manual (Page 15)

-15-
This section describes the various setting
option of this player.
If the setup option is grayed out, it means
the setting cannot be changed at the
current state.
General Setting
1. The DVD Player and TV will be opened,
after they are connecting the power.
- [General Setting] menu is displayed.
2. Press . Press Press  to select an option, then press
 to access.
System Screen Saver On
On
On
On
More...
Use cursor key to move focus,use
“Enter ” key ro select
Language Disc Auto Playback
Playback CEC
Security Disc Auto Upgrade
Network Load Default
... General Setting ...
Home Exit
. Press . Press Press  to select a setup option and to select a setup option and
press  .
4 . Select the setting you wish to change
and press OK to confirm.
- Press  to return to the previous
menu.
[System]
To change the following system option to
personalize your BD player.
• [Screen Saver]
Turn on or Off the screen saver mode.It
helps to protect the TV screen.
{ On } – Set the screen saver active
after 10 minutes no operation.
- The BD player will switch to standby
mode if there is no operation till 25
mintues.
{ Off } – Turn off the screen saver
mode.
•• [Disc Auto Playback]
Turn On or Off the disc automatic
playback switching model.
{ On} – The disc auto playback after
loading.
{ Off} – Turn off disc auto playback
mode.
• [CEC]
This player supports Easylink which
uses the HDMI CEC (Consumer
Electronics Control) protocol. You can
use one single remote control to control
all EasyLink-compliant devices that are
connected through HDMI connectors.
{ On} - Turns on EasyLink features.
{ Off} - Disables EasyLink features.
• [Disc Auto Upgrade]
Turn on or Off the disc automatic
upgrade switching models.
{ On} - Start upgrade from the insert
disc.
{ Off} - Disable disc auto upgrade mode.
• [Load Default]
Reset all settings of DVD player to intial
default state.
- Follow the instruction on the TV screen
to confirm the default setting operation.
1. Select Load Default.
2. A dialog box pops up shown as
below. Select OK.
Load Default
OK Cancel
Do you want to load default?
. Load Default it in progress, which
may take a while. Please wait...
Load Default
30%
Loading default, please wait...
4. TV will display as follows:
Welcome
ENTER Next
to use BD Player Setting wizard!
Some simple settings are needed before you
enjoy it. Please make detail settings of home
menu later.
5. Press . Press OK, enter language setting.
Press to select a language option. to select a language option.
Choose
Previous
an OSD language before starting.
The language selected will be applied not only
here but also in other OSD windows, menus etc.
English
French
ENTER Next
Customizing