SONIQ QV210C - Manual (Page 3)

.2.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION: TO PREVENT ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK).NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The graphic symbols on the back cover of the set mean the following:
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the
presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magni-
tude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
INSTALLATION
LOCATE the receiver in the room where direct light does not strike the screen. Total darkness or a reflection on the picture
screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing.ALLOW enough space
between the receiver and the wall to permit proper ventilation.AVOID excessive warm locations to prevent possible damage
to the cabinet or component failure.
CONNECTION
This TV power plug can be connected to 230V~ 50/60Hz, NEVER connect to DC supply or any other power.
AUTOMATIC DEGAUSSING
All colour television receivers are sensitive to magnetic influences, usually caused by either moving the receiver from one
place to another or using certain electrical appliances near the receiver. This residual magnetism as it is called, sometimes
causes distortion which gives rise to "blotchy" areas of colour in the picture. To avoid these effects the receiver incorporates
an automatic degaussing circuit which operates for a short while immediately each time the receiver is switched on using the
mains switch. This circuit removes any residual magnetism in the metal parts of the picture tube and therefore ensures that
each time the receiver is switched "ON" using the Mains switch, the purity of the colours displayed on the screen remain true
and lifelike. If the set is moved or faced in a different direction , the mains switch must be switched off at least 10 minutes in
order that the automatic degaussing circuit operates properly.