SoundOff Signal nFORCE Oval Recess Mount - Manual (Page 2)

ENFSRV(xx) 10.14
SECONDS USER INTERFACE
FROM TO VISUAL FEEDBACK ACTION TAKEN
0 1 STEADY-HIGH (60%) FORWARD ONE PATTERN
1 2 STEADY-LOW (30%) BACKWARD ONE PATTERN
2 3 OFF COLOR SWAP (OFF OR ON )
3 4 STEADY - HIGH (60%) SIMULTANEOUS OR ALTERNATE
4 5 STEADY - LOW (30%)
SEPARATE COLOR CONTROL
(OFF OR ON)
5 6 OFF RESET TO PATTERN 1
6 7 STEADY-HIGH (60%)
FACTORY RESET (PATTERN 1, COLOR
SWAP: OFF, SEQUENCE TYPE:1)
SEPARATE COLOR CONTROL: OFF
If held longer than 7 seconds, the light will go back to flashing the current
pattern and no action will be taken.
AFTER POWER IS ON, touching the WHITE or Yellow (Dual)
wire to the ground will allow you to change various setting on
the module. (See table below)
2.
*
SLAVE MODE
The nFORCE is capable of being activated through the use of a user supplied flasher by putting it in Slave Mode.
1. Permanently connect the nFORCE WHITE and BLACK wire (or WHITE/BLACK and YELLOW wire for second
module of Dual Light) to a good, convenient ground.
2. Connect the nFORCE RED wire, *(Dual use RED & ORANGE wire) through a 5amp fuse, to the output of a
+10-16Vdc switching flasher.
6” OVAL CUTOUT TEMPLATE
2.50
6.75
1.25” Radius x2
IMPORTANT NOTE:
Due to variations in the printing process and environmental factors, the sizes
shown may not be accurate. If this document is used as a cutting template,
it is the installer’s responsibility to confirm the accuracy of the dimensions
shown and adjust accordingly.