SoundOff Signal 3000 Strobe Beacon Metal Branch Guard - Manual

BEFORE ATTEMPTING INSTALLATION,
BE SURE YOU FULLY READ AND
UNDERSTAND ALL INSTRUCTIONS.
TO MOUNT THE 4" OR 6" BRUSH GUARD:
1) Remove the 1/2" screws holding the lens in
place.
2) Place the brush guard over the lens using either
the dress ring or the clear dome as a spacer.
Note: the 6" brush guard must be used with the
clear dome and either the 4" or 6" guard may be
used with the dress ring.
3) Secure the brush guard with the 3/4" screws
supplied. DO NOT OVERTIGHTEN! as this may
damage the beacon or brush guard.
6" BRUSH GUARD (E360BG6)
4" BRUSH GUARD (E360BG4)
CLEAR DOME (CONFORMS TO
CALIF. TITLE XIII REQUIREMENTS)
DRESS RING
1/2" SCREW
(REMOVE)
3/4" SCREW
(INSTALL)
REMOVE 1/2" SCREWS AND
REPLACE WITH THE 3/4"
SCREWS SUPPLIED.
6" BRUSH GUARD SHOWN
INSTALLED OVER 6" BEACON
AND CLEAR DOME
E360BG(x) 3/05
Stainless Steel Brush Guard
E360BG(x)