Stealth Cam STC-WD2IR I230IR - Manual (Page 25)

STC-WD2-IR
www.stealthcam.net Toll Free 877-269-8490 25
Using the camera in PIR detection mode
• Mount the camera to tree or other sturdy object using either
supplied tree screw or mounting strap (Please refer to the
mounting suggestions section in this manual)
• Open the front housing and move the switch to the ON position.
At this point you have 30 seconds to make any program
adjustments.
• After 30 seconds the camera’s green test light will begin
blinking and enter count down mode. This is your indication to
leave the coverage area with one minute.
• After one minute the camera will take between 1~3 pictures or
a 10 seconds AVI video based on your program setting. The
camera will then time out between 1 ~ 60 minutes also based
on your setting.
The time between motion detection and the camera taking
the pictures may vary due to lighting conditions, program
setting and battery power level.