Stealth Cam STC-AD3 I390 - Manual (Page 30)

STC-AD3
www.stealthcam.net Toll Free 877-269-8490 30
Using the camera in PIR detection mode
• Mount the camera to tree or other sturdy object using either
two supplied tree screw or mounting strap (Please refer to the
mounting suggestions section in this manual)
• Open the front housing and move the switch to the ON position.
• The camera’s green test light will begin blinking and enter
count down mode. This is your indication to leave the coverage
area within one minute.
• After one minute the camera will take between 1~3 pictures or
a 10 seconds AVI video based on your program setting. The
camera will then time out between 1 ~ 60 minutes also based
on your setting.
™ The time between motion detection and the camera taking
the pictures may vary due to lighting conditions, charging
of the flash, program setting and battery power level.
™ The flash light will only activate in low light conditions
when set in Auto Flash.
™ When the camera is set to AVI capturing, the 10 seconds