Teradek Bolt Pro 2000 - Manual (Page 2)

BEST PRACTICES
BOLT LEMO CONNECTOR / PIN−OUT
CUSTOM / 3RD PARTY CABLES
DEVICE OPERATION
MOUNTING
Bolt uses a 0B 302 series LEMO connector (FGG.0B.302.CLADxx).
Pin Description
1* GND
2 +DC
* Pin 1 is closest to the red dot on the LEMO connector
• Test the power cable polarity with ONLY the power cable connected to Bolt. Do not connect video cables.
• Check the power cable for shorts and proper grounding.
Best Practices
• Keep the transmitter and receiver at close range for 60 seconds after powering on the devices. This allows
them to scan for and select the best wireless channel.
• If the receiver loses signal due to interference or it exceeds the maximum range, do not power down either
device. If the devices remain powered they will reconnect more quickly.
• If either device loses power, regardless of whether or not the link was established, both must be power
cycled before the link can be restored.
• For best results when using multiple Bolt systems in the same area, place the transmitters and receivers
a few feet apart from each other.
• Operation of other wireless equipment may interfere with the BP2K; for best results, separate other
wireless transmitters and receivers as much as possible.
• Mount the Bolt Pro 2000 transmitter vertically, keeping the antennas clear of any obstructions.
• Orient the transmitter and receiver antennas so they are parallel to each.
• For best results, orient the receiver antennas so each one has clear line−of−sight to the receiver.
CAUTION:
Using a reverse polarity or improperly−constructed power cable can damage the product
and is not covered under warranty.
Bolt Transmitter mounted
vertically on a camera
Bolt Receiver mounted
vertically on a monitor