Teradek Bolt - Manual (Page 2)

BEST PRACTICES
BOLT LEMO CONNECTOR / PIN−OUT
CUSTOM / 3RD PARTY CABLES
OPERATION
MOUNTING
Bolt uses a 0B 302 series LEMO connector (FGG.0B.302.CLADxx).
Pin Description
1* GND
2 +DC
* Pin 1 is closest to the red dot on the LEMO connector
• Check the power cable for shorts / proper grounding.
• DO NOT connect video when testing custom cables. Improper cable polarity and/or construction
may cause damage to Bolt if video is connected.
• For best results, allow 60 seconds after powering up the Transmitter and Receiver for them to select
the best frequency.
• For better signal quality over longer distances, maintain line−of−sight between the Transmitter
and Receiver.
• Mount the Bolt Transmitter vertically.
• Mount the Bolt Receiver vertically with the face oriented towards the Transmitter.
• Keep the antennas on the Bolt Transmitter and Receiver clear of obstructions.
• Velcro is not recommended for mounting either Transmitter or Receiver.
Bolt Transmitter mounted vertically on a camera
Bolt Receiver mounted vertically on a monitor
ALWAYS MOUNT BOLT TRANSMITTER VERTICALLY ALWAYS MOUNT BOLT TRANSMITTER VERTICALLY
CAUTION: Damage to the product caused by custom cables is not covered under warranty.