Teradek Cube Reference Guide - Manual (Page 15)

Version 2 Dec „11 © Teradek, LLC 2011. All rights reserved.
Page | 15
2.1. To pair two Cubes without using a computer, hold both devices‟ ‟Go Live!‟ buttons until the
ENC/DEC and WiFi LEDs blink green rapidly. NOTE: if set to „Live Internet Streaming‟ mode, the
encoder will attempt to start a broadcast before entering pairing mode.
2.2. After a short time, the decoder will restart and connect to the encoder.
3. Switching between available streams
3.1. Open your Cube decoder‟s web UI and log into the device.
3.2. Navigate to „Video Setup‟ -> „Decoder Settings.‟
3.3. Choose a video stream from the list of „Available Video Streams‟ and drag it to the „Decoder
Channel 1‟ box.
3.4. Click „Apply.‟ So long as the chosen stream is valid and both Cubes are on the same network,
the decoder will search for and connect to selected stream.
4. Manual configuration
4.1. Refer to the Configuration pages section, page 18, for information about manual decoder
configuration.
Stream Modes
Depending on your video‟s ultimate destination, you can pick from a variety of different stream types.
Cube‟s included stream types are described in this section. For information on the other activatable
options, please refer to Advanced and/or activatable applications, page 30. All stream configuration is
done via the web UI on the „Video Setup‟->‟Stream Settings‟ page.
1. RTP/RTSP
1.1.