Trail Master Suspension TM3415-20013 JEEP WRANGLER (TJ) 1.5 POLY SPACER KIT - Manual (Page 4)

4
Prepare to Install Front
Suspension
1. Loosen, but do not remove, lug nuts on each
front wheel.
2. Place the vehicle in neutral. Place your floor
jack under the front axle and raise the vehicle.
Place jack stands under the frame rails and
lower the frame onto the stands. Remove the
jack and place the vehicle back in gear, set the
emergency brake, and place blocks both in front
and behind the rear wheels. Remove the front
wheels.
3. Unbolt and remove the transmission skid plate
from the vehicle.
4. Unbolt the front sway bar end links from the
axle. Save the hardware for reuse.
5. Unbolt the lower front shock mount on both
sides of the vehicle. If you purchased kits
TM3415-20012 or TM3415-20013 unbolt and
remove the front shocks from the vehicle. It
may be necessary that you slightly raise the
axle to unload the shocks for removal.
6. Unbolt the front track bar from the front axle
mount and secure up and out of the work area.
Save the hardware for reinstallation.
7. Unbolt the all the ABS mounting clips from the
vehicle.
8. Unbolt the front brake line brackets from the
frame.
9. Lower the front axle enough to remove the coil
springs from the front spring pockets. Save the
factory isolators for re-use. Be sure to support
the axle while the springs and shocks are re-
moved.
10. Remove the front bump stops and unbolt the
bump stop-mounting cups.
Install Front Suspension
1. Install the front poly spacers (15-11515) and iso-
lator over the bump stop mount. Reinstall the
bump stop cup using the previously removed
OE hardware.
WARNING
Compressed coil springs can expand violently causing
serious personal injury. Before removing the coil
springs, lower the axle housing as far as possible to al-
low the coil springs to expand.
WARNING
Use extreme caution when lifting vehicle from ground.
To prevent serious personal injury, ensure the lifting de-
vice is securely placed.
Front
Spring
Pocket
Front
Bump Stop
Mounting
Cup
Front
Bump Stop
Mount
OE
Bolt
Front
Spring
Isolator
15-11515
Front Poly
Spacer
Front
Bump Stop
Mounting
Cup
Front
Bump Stop
Mount