Trail Master Suspension TM3330-40053 JEEP WRANGLER 4 DOOR (JK) 3 SPRING KIT - Manual (Page 5)

5
3. With the front axle supported, unbolt the lower
front control arm from the front axle mounts.
4. Using a chisel, remove the alignment plates
from the factory mounts.
5. Reinstall the front lower control arms to the axle
mounts using the supplied alignment plates.
Rotate the plates so that the large lobe is facing
toward the front of the vehicle. Torque to
95 ft./
lbs.
6. Carefully lower the front axle to ease in the new
coil spring installation. Using the factory isola-
tors install the coil springs (TM3330-60030) into
the spring buckets
7. Install the coil spring and bump stop spacer at
the same time. Secure the bump stop extension
using the 3/8” self tapping bolt. DO NOT over
tighten.
8. Raise the front axle into place. Make sure the
coil spring seats properly on the lower spring
perch.
9. Now would be a good time to inspect the front
shocks for damage or fluid leakage. Replace if
necessary.
10. If you purchased kit TM3330-40020 ,install the
front shock extension bracket (82-TM20005) us-
ing the previously removed OE bolt and hard-
ware and the 8mm X 20mm bolt and hardware.
11. Carefully raise the front axle and install the
lower shock mount to the shock extension
bracket (82-TM20005) using the 12mm X
75mm bolt and hardware.
12. If you purchased kit TM3330-40053 Install your
new front shocks (TM73265005) and install the
lower shock mount to the axle mount using the
previously removed OE hardware.
13. Torque the 12mm and OE shock hardware to
87 ft./lbs. Torque the 8mm hardware to 17 ft./
lbs.
14. Reinstall the OE front sway bar end link into
original mounting bracket on the axle using the
previously removed OE hardware. Torque to
manufacturers specifications.
35-TM20041
Alignment
Plate
8mm X
20mm bolt
OE bolt
12mm X
75mm bolt
Front
Shock
82-TM20005
Front Shock
Extension
TM3330-
60030 Front
Coil Spring
90-TM10001
Bump Stop
Extension
Front
Axle