Tundra HTS3024 - Manual (Page 15)

HTS-1824_3024-GD-0114-EN 4
AC Outlets: Never exceed 1800w (or 15A) per outlet. It may result in extensive damages to your
inverter and lead to injuries.
Hard wire outlet:
HTS models are also equipped with one hard wire outlet which can be used as the only
output socket up to the maximum capacity of the inverter.
CAUTION! Leave inverter in the OFF position during the installation.
2.2 Rear panel
Chassis ground screw: The inverter has a lug on the rear panel to perform a grounding procedure (when
required) to derive AC leaks to ground in case of malfunctioning. Refer to section 3.5
for more details.
Fan(s): In order for the inverter to properly operate, the fan(s) opening must never be
obstructed. Allow at least 6 inches (15.2 cm) of clearance around the inverter for
airflow. All fans are thermostatic and operate upon the interior temperature of the
inverter.
CAUTION!
Fan(s) will continue to run even if the inverter is on shutdown.
2.3 LCD remote control
Your new inverter is equipped with an LCD remote control. During normal operation of the inverter, the remote
will display a number of information to allow its user to better understand the operational limits of the inverter.
The information displayed can be used to obtain maximum performances as well as troubleshooting.
On HTS Series the remote control is factory installed on the front panel, but detachable. It allows mounting of
the inverter out of sight. The remote can be mounted remotely using the included hardware and the 19.7 feet
cord (6m).