Getting started, Step 1: preparing the power supply – Canon DC100 EN User Manual

Page 17

Advertising
background image

17

P

re

p

ar
at

io

n

s

E

Preparations

Getting Started

Step 1: Preparing the Power Supply

The camcorder can be powered with a battery pack or directly using the compact power
adapter. Charge the battery pack before use.

1. Turn off the camcorder.

2. Attach the battery pack to the

camcorder.

• Open the LCD panel.
• Slide in the connector end of the battery

in the direction of the arrow and press it
gently until it clicks.

3. Connect the power cord to the

compact power adapter.

4. Plug the power cord into a power

outlet.

5. Connect the compact power

adapter to the camcorder’s DC IN
terminal.

• The CHG. (charge) indicator starts

flashing. The indicator will stay on when
the charging is completed.

• You can also use the compact power

adapter without attaching a battery pack.

• When the compact power adapter is connected, even if a battery is attached its

power will not be consumed.

Once the battery is fully charged:

1. Disconnect the compact power adapter from the camcorder.

2. Unplug the power cord from the power outlet and the compact power

adapter.

To remove the battery pack:

Slide down

to release the battery pack, and pull out

the battery pack holding it from the ridge on its bottom part.

Charging, Recording and Playback Times with the BP-208 Battery Pack

The charging time of the BP-208 battery pack is 165 min.

The following recording and playback times are approximate and vary according to the
charging, recording or playback conditions.

BATTERY
RELEASE
switch

DC IN terminal

CHG. (charge) indicator

Remove the battery terminal cover
before attaching the battery

BATTERY RELEASE

Advertising