Unitec C-Start Installation Manual - Manual (Page 22)

C - S T A R T
Document Number: CST1001 18
Appendix C – Terminating Ethernet Cables
1. Carefully remove the outer jacket of the cable. Be careful when stripping the jacket as to
not nick or cut the internal wiring. One good way to do this is to cut lengthwise with snips
or a knife along the side of the cable, away from yourself, about an inch toward the open
end. This reduces the risk of nicking the wires' insulation. Locate the string inside with the
wires, or if no string is found, use the wires themselves to unzip the sheath of the cable by
holding the sheath in one hand and pulling sideways with the string or wire. Cut away the
unzipped sheath and cut the twisted pairs about 1 1/4" (30 mm). You will notice 8 wires
twisted in 4 pairs. Each pair will have one wire of a certain color and another wire that is
white with a colored stripe matching its partner (this wire is called a tracer).
2. Inspect the newly revealed wires for any cuts or scrapes that expose the copper wire
inside. If you have breached the protective sheath of any wire, you will need to cut the
entire segment of wires off and start over at step one. Exposed copper wire will lead to
cross-talk, poor performance or no connectivity at all. It is important that the jacket for all
network cables remains intact.
3. Untwist the pairs so they will lay flat between your fingers. The white piece of thread can
be cut off even with the jacket and disposed (see Warnings). For easier handling, cut the
wires so that they are 3/4" (19 mm) long from the base of the jacket and even in length.
Document Name: C-Start Installation Manual