Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 19)

W A S H S E L E C T I I
Document Number: WS21002 7
Document Title: WSII Operations Manual ver 5.50
2 Initial Setup
The Wash Select II configuration menus provide the ability to customize your unit to interface
with your site-specific options, wash equipment, and marketing plans. The following sections
provide configuration procedures for each of the available menu functions.
If you are integrating the Wash Select II with the WashPay Site Management System, ensure
the expansion board is installed in the upper right corner above the CPU board on the inside
right wall of the WSII unit and is connected to the CPU board with a short ribbon cable. A
CAT5E Ethernet cable will be connected from the expansion board to the router in the
office/C-store. Then complete the following steps:
1. Place the WSII in Setup mode. Scroll to: Credit System (*) Credit Mode (*) 6 (*)
2. The Version of the installed expansion board will be displayed. If the board is not
connected correctly, the error “NIC not found!” will be displayed on the LCD
windows on the door. The credit mode will not save and the system will not
connect to the WashPay server until this is corrected.
3. Scroll to Network Params (*)
4. You should see “Rev#: WP2.XX. Press any key.” Press any key to continue. If
this message is not displayed, make sure the LED light is lit on the expansion
board by the Ethernet cable and make sure the ribbon cable and Ethernet cable
connections are secure, then reboot the Wash Select II unit.
5. The network status will be displayed:
host connected: communication to the server is established (or)
network online: server connected, but no communication (or)
network down [x]: where x equals one of the following error codes:
1 - No DHCP returned
2 - Cannot create TCP server
3 - Cannot set up UDP socket
4 - Cannot find controller
5 - Did not connect to TCP server
6 - Did not get a device ID
no response: No response from the interface (If "no response", set up will
exit.)
6. The parameters will be sent to the network interface. If successful, it shows "IP
addresses set", otherwise "Cannot Set IP".