Valco Baby Astro High Chair - Manual (Page 3)

SAFETY HARNESS
Your High Chair is fitted with a 5 point safety harness
system. Your child MUST always be harnessed
while in the high chair.
FIgURE E: USINg YOUR HARNESS
TO SECURE YOUR CHILD IN THE HARNESS:
8. Insert Buckles (a) and (b) into either side of the
Buckle Housing (c). Keep inserting until they click
into place securely.
9. Carefully adjust the harness straps to snugly fit
your child by adjusting the Sliders located on all
Shoulder Straps, Waist Straps and Crotch Strap.
The harness should be snugly fitted to the baby’s
body, tight enough so that the baby cannot wriggle
itself free of the straps but loose enough so as not
to cause the baby any discomfort.
TO OPEN THE HARNESS:
10. Release the Buckle Prongs – Squeeze on the top
and bottom prongs simultaneously and pull apart
from the Buckle Housing.
THIS PROCESS MAY BE DIFFICULT AS YOUR BUCkLE SYSTEM
HAS BEEN DESIGNED TO MEET vERY STRINGENT SAFETY
STANDARDS TO ENSURE THAT A CHILD CANNOT RELEASE
THE HARNESS UNAIDED.
CLOSINg THE HIgH CHAIR
FIgURE F
11. Locate the release latch on the back of the seat
(d) and the frame lock (e) on the side of the seat
frame.
FIgURE g
12.Push the footrest into the upright position and
remove the food tray (if desired - your High Chair
can be folded with the food tray in position).
13. Lift the release lock and simultaneously
disengage the frame lock by pulling the plastic tab
free of the locking pin.
14. gently ease the seat down until it has fully
collapsed into the closed position.
NOTE: YOU MAY NEED TO PLACE YOUR FOOT ON THE LOWER
FRAME TO HOLD THE UNIT IN POSITION WHILE LOWERING.
E
F
g
b
c
a
d
e