Valco Baby Zee Two - Manual (Page 4)

H
FIGURE H - BUMPER BAR
19. Insert the front bar ends into the nylon housings
located on either side of the frame. Be sure that the
moulded arrows are facing forward, away from the frame.
Be sure that the bar is securely engaged.
20. Wrap the crotch strap around the installed bumper bar
and snap into position
21. Adjust the front bar by simultaneously pressing the
button on the bar housing and swivelling the bar to the
uppermost position. This is the only position for use
with a child in the stroller.
22. To remove the front bar: Feeling the side of the nylon
housing that sits below the frame at each side (facing
inward), locate the release button.
23. Press each release button inward while simultaneously
pulling upward on the bar housing. Repeat for the other
side. Note that this may be difficult to do as the bar is
secured firmly as a safety precaution.
IMPORTANT WARNING: THE FRONT BAR IS NEITHER A
RESTRAINING NOR CARRYING DEVICE.
FIGURE I - SEAT RECLINE
Our system offers an almost infinite amount of individual
seat adjustments.
24. TO RECLINE: While squeezing the centre release
mechanism in a pincer action, ease the seat down to the
desired position.
25. TO INCLINE: Place your hand at the centre of the rear
of the seat. Pull the incline strap while gently pushing on
the rear of the seat until the desired position has been
reached.
FIGURE K- ADJUSTING YOUR FOOTREST
26.To adjust your foot rest downward, press the central
buttons on either side of the footrest while
simultaneously adjusting it up or down.
YOUR FOOTREST IS DESIGNED TO COLLAPSE IF EXCESS
WEIGHT IS APPLIED TO IT
FIGURE L
Each Expanda hood unzips, increasing the size of the
standard hood to give it greater coverage and protection
from the sun and weather for your child.
To open the Expanda Hood:
27. Locate the zip in the center of the Expanda Hood and
unzip completely
28. Gently pull the Expanda Hood forward until it is reaches
its full extension.
To close the Expanda Hood:
29. Gently push the Expanda Hood back, allowing the
middle section to fold in on itself.
30. Carefully zip the Expanda Hood closed.
PRESS
PULL
I
click
K
L
IMPORTANT HOOD INSTALLATION INSTRUCTION
The Expanda hoods come fixed to the stroller.
Secure the rear hood skirt to the frame
by passing the press stud through the slot
provided and firmly engaging the other half by
pressing strongly. Always test that the press
studs are fully and firmly engaged.
▲ ! ▲ !
HOOD SKIRT
SEAT SIDE