Valco Baby Tri-mode Graco - Manual (Page 6)

A
B
Insert Car Seat Adaptor
Remove Bumper Bar or Housing
Bumper Bar
Nylon Plug
press
to reMoVe the car seat:
detach the straps (reversing the
process outlined in d) and lift up the
car seat to unlock it from the frame.
to reMoVe the car seat adaptor:
locate the two nylon release buttons
that sit below the frame at each side of
the stroller.
press the release button and lift the
adaptor bar out of the nylon housings
for Use with britax
single/twin
car seat adaptor:
If you haven’t already done so, remove
the front bar or plugs from the nylon
housings on either side of the stroller
frame by pressing each inner ‘release
button’ and lifting the front bar or plug
from the housing.
Insert the car seat adaptor connecting
pieces into the nylon housings.
Be sure that the bar release button is
securely in the housing.
TWIN ADAPTOR HINT:
When positioning the adaptor, make
sure that the raised end of the adaptor
bar will be resting in the seat portion of
the stroller when connected.
A
B
E
Remove Adaptor
E
5