Valco Baby RAD - Manual (Page 3)

Your seat section
1. Line up each of the seat
connectors with the corresponding
housing located on either side of
the stroller frame.
2. Insert the connecters into the
housing until the seat is securely
in place.
1. Insert the two bumper bar pins in to
the housing located in the side
connectors of the seat.
2. To remove the bar, press on each of
the buttons and lift the bar out of
the housing. Your bar can also
operate as a “gate” by opening only
one side!
To remove the seat or face it in the
opposite direction:
1. Simultaneously press both grey
buttons located on either side of
the seat unit and lift the seat unit
from the frame.
NEVER remove the seat with a child in
it.
1. To install your hood, place each
clamp around the seat tube so
that the locking rivet is located in
the centre of the plastic clamp.
2. To remove, lift each clamp over the
locking rivet and lift off the canopy.
1. To adjust your footrest,
simultaneously press the two
adjusting buttons on either side of
the footrest and move it up or
down to the desired position. 1. Your handle can be adjusted to
multiple positions.
2. Press the centre locking button
while simultaneously moving the
handle up or down.
3. Releasing the locking button will
allow the handle to lock into the
next available handle position.
Using your harness
Your stroller is fitted with a multi point safety harness system. Your child MUST always be harnessed while in the stroller.
1. Insert Buckles (A) and (B) into either side of the Buckle Housing
(C). Keep inserting until they click into place securely.
2. Carefully adjust the harness straps to snugly fit your child by
adjusting the Sliders (D) located on all Shoulder Straps, Waist
Straps and the Crotch Strap.
3. To open the harness, release the Buckle Prongs by squeezing on
the top and bottom prongs simultaneously and pull apart from the
Buckle Housing.
This process may be difficult, as your buckle system has been
designed to meet very stringent safety standards to ensure
that a child cannot release the harness unaided.
The harness should be snugly fitted to the baby’s body, tight enough so that the baby cannot
wriggle itself free of the straps but loose enough so as not to cause the baby any discomfort.
IMPORTANT WARNING: Always check that all chassis hinges are securely engaged before use.