Valco Baby Ion Car Seat Adaptor - Manual (Page 2)

A
B
C
D
CAR sEAT ADAPTOR
FIGURE A
1. Begin preparing the Ion stroller for the Car seat Adaptor
by reclining the seat to its fully reclined position.
2. Remove your adaptor bar from packaging.
BE sURE yOUR ADAPTOR BAR Is THE CORRECT ONE FOR
yOUR CAR sEAT By CHECkING THAT THE wHITE lABEl
ON yOUR ADAPTOR BAR MATCHEs yOUR PRODUCT
DEsCRIPTION.
CONTACT VAlCO BABy AT [email protected] IF yOUR
PRODUCT DEsCRIPTION DOEs NOT MATCH.
FIGURE B
REMOVING BUMPER BAR
3. Undo the snaps of the leg divider.
4. Undo the snap pockets covering the bumper bar on the
side of your stroller.
5. locate the Release lever on the bumper bar where the
bumper bar connects to the stroller.
FIGURE C
6. slightly lift the Release lever to disengage the bumper
bar.
7. slide bumper bar up, and off the stroller.
FIGURE D
INsTAllING ADAPTOR
8. Take adaptor bar and slide it onto the stroller connection
point until it clicks.
THE ADAPTOR BAR Is NOT sECURE ON yOUR sTROllER
UNTIl IT ClICks INTO PlACE AND CANNOT BE REMOVED
UNlEss lEVER Is lIFTED. IF yOUR ADAPTOR BAR sIMPly
slIDEs OFF THE sTROllER FRAME. IT Is NOT sECURE.
I
Car Seat Adaptor
Bumper Bar
Recline Seat
Locate adaptor/
bumper bar
connection point
Lift Lever
Remove bumper bar
slide
Slide adaptor onto stroller