CREATIVE PC-CAM 900 - Manual (Page 36)

Installing Creative PC-CAM 900 4-4
10. If an Unsafe Removal of Device
dialog box appears, click the OK
button.
11. When Digital Signature Not
Found dialog boxes (Figure 4-3)
appear, telling you that Creative
PC-CAM 900 has been detected,
click the Yes button.
12. Click the Finish button and restart
your computer if you are prompted
to do so.
For Windows 98/98 SE and Windows Me only
8. If you are prompted to insert the Windows 98/98 SE Installation CD, replace
the Creative PC-CAM 900 Installation CD with the appropriate CD. If you did not
receive a Windows 98 SE installation CD with your computer but received a
Recovery Disk, the necessary Windows files may already be located at
c:\windows\options\cabs (replace c:\ with the drive letter of your hard
disk drive).
Note: Windows 98 is available in various editions. Be sure to use the correct
edition for your system.
9. In the Insert Disk dialog box, click the OK button.
10. When the New Hardware Found message boxes close, wait approximately 5
seconds, and then turn your camera’s Mode Selector dial to Web Cam
mode.
11. If an Unsafe Removal of Device dialog box appears, click the OK button.
Figure 4-3: Digital Signature Not Found
dialog box